Functions specific to SCALANCE
3.4 SRS
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
99
Commands in the SRS configuration mode
This section describes commands that you can call up in the SRS configuration mode.
In the Global configuration mode, enter the
srs command to change to this mode.
● If you exit the SRS configuration mode with the
exit command, you return to the Global
configuration mode.
● If you exit the SRS configuration mode with the
end command, you return to the Privileged
EXEC mode.
Note
This command is only available with a KEY
-PLUG.
With this command, you configure the time after which the IPv4 address will be transferred to
the required destination server.
You are in the SRS configuration mode.
The command prompt is as follows:
cli(config-srs)#
Call up the command with the following parameters:
interval <time (60-86400)>
The parameter has the following meaning:
The interval is configured.
You display this setting and other information with the show srs overview command.
To Next Page
Loading...
Need help?
General
