Network protocols
6.5 DNS
SCALANCE S615 Command Line Interface
212 Configuration Manual, 06/2015, C79000-G8976-C406-02
You are in the DNS CLIENT configuration mode.
The command prompt is as follows:
cli(config-dnsclient)#
Call up the command with the following parameters:
no manual {srv <ip_addr>|all}
The parameters have the following meaning:
IPv4 address Enter the IPv4 address of the
The specified DNS server is deleted.
You create a DNS server entry with the manual srv command.
You display this setting and other information with the
show dnsclient information
command.
With this command, you specify which DNS server the device uses.
You are in the DNS CLIENT configuration mode.
The command prompt is as follows:
cli(config-dnsclient)#
Call up the command with the following parameters:
server type {all | manual | learned}
To Next Page
Loading...
Need help?
General
