System time
4.1 System time setting
SCALANCE S615 Command Line Interface
124 Configuration Manual, 06/2015, C79000-G8976-C406-02
With this command, you configure the way in which the system time is obtained.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
time{manual|ntp|sntp|SINEC}
The parameters have the following meaning:
The system time is entered by the user
The system time is obtained from an NTP server
The system time is obtained from an SNTP server
The system time is obtained using the "SIMATIC time protocol"
The method of obtaining the system time is configured.
You display the settings for the system clock with the show time command.
To Next Page
Loading...
Need help?
General
