EasyManuals Logo

Siemens SCALANCE S615 Configuration Manual

Siemens SCALANCE S615
442 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #289 background imageLoading...
Page #289 background image
Layer 3 functions
8.1 NAT
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
289
8.1.3.1
masquerading
Description
With this command, you enable the rules for IP masquerading on the interface.
Requirement
VLAN interface with subnet assignment
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Syntax
Call up the command with the following parameters:
masquerading <interface-type> <num(0-4094)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
interface-type
Type or speed of the interface
Specify a valid interface.
num
Number of the addressed VLAN Specify a valid interface
index.
0 ... 4094
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL NAT configuration mode (Page 288)".
Result
The rules for IP masquerading are enabled on the specified interface.
Further notes
You disable IP masquerading with the no masquerading command.
You configure the subnet assignment with the
map subnet command.
You display the setting with the
show masquerading command.
8.1.3.2
no masquerading
Description
With this command, you disable the rules for IP masquerading on the interface.

Table of Contents

Other manuals for Siemens SCALANCE S615

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE S615 and is the answer not in the manual?

Siemens SCALANCE S615 Specifications

General IconGeneral
ProtocolsIPsec, OpenVPN
Power Supply24 V DC
Mounting TypeDIN Rail
Product NameSCALANCE S615
Ports5
FirewallYes
Weight0.6 kg
CertificationsCE

Related product manuals