Functions specific to SCALANCE
3.4 SRS
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
103
The specified destination server entry is deleted.
You create a destination server entry with the logon addr command.
You display the numbers of the destination servers with the
logon show-idx command.
Note
This command is only available with a KEY
-PLUG.
With this command, you change address of a specific destination server.
You are in the SRS configuration mode.
The command prompt is as follows:
cli(config-srs)#
Call up the command with the following parameters:
logon idx <num(1-100)> addr <ip_addr|dns(50)>
The parameters have the following meaning:
Number corresponding to a specific
Enter the required number.
IPv4 address Enter the IPv4 address of the
DNS host name Enter the DNS host name of the
proxy server.
The address of the destination server has been changed.
To Next Page
Loading...
Need help?
General
