Diagnostics
10.1 Event and fault handling
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
417
With this command, you show the messages that occurred during communication via a
secure VPN tunnel. The messages can be filtered according to the event severity.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show seclog [{ info | warning | critical }]
The parameters have the following meaning:
If you use the command without setting parameters, all messages are displayed.
The content of the security log is displayed.
To Next Page
Loading...
Need help?
General
