Siemens SCALANCE S615 - End; Exit

Description
1.6 General CLI commands
SCALANCE S615 Command Line Interface
30 Configuration Manual, 06/2015, C79000-G8976-C406-02
1.6.3
end
Description
With this command, you exit the configuration mode and are then in the Privileged EXEC
mode.
Requirement
You are in a configuration mode.
Syntax
Call the command without parameters:
end
Result
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
1.6.4
exit
Description
With this command, you close the current mode.
Syntax
Call the command without parameters:
exit
Result
The current mode was exited. You are then at the next higher level.
If you are in Privileged EXEC Modus or in User EXEC Modus mode, you will be logged out.