Functions specific to SCALANCE
3.5 SINEMA RC
SCALANCE S615 Command Line Interface
122 Configuration Manual, 06/2015, C79000-G8976-C406-02
Note
This command is only available with a KEY
-PLUG.
With this command, you configure the fingerprint of the device. The fingerprint is assigned
during commissioning of the SINEMA RC Server. You will find further information on this in
the Operating Instructions of the SINEMA RC Server.
You are in the SINEMARC configuration mode.
The command prompt is as follows:
cli(config-sinemarc)#
Call up the command with the following parameters:
verification fingerprint <string(59)>
The parameter has the following meaning:
Fingerprint of the device Specify the fingerprint of the
device.
The fingerprint is configured. Based on the fingerprint, the device checks whether the correct
SINEMA RC Server is involved.
You display this setting and other information with the show sinemarc command.
To Next Page
Loading...
Need help?
General
