Configuration
2.1 System
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
53
The parameter has the following meaning:
Input box for the longitude coordinate max. 32 characters
To use spaces in the entry, enter
the longitude coordinate in
quotes:
coordinates longitude
The longitude coordinate is created.
With this command, you change to the Interface configuration mode.
There you can edit the settings for one interface. You select the interface with the
parameters of this command. If you specify a logical interface that does not exist, it will be
created. The name of the selected interface is displayed in the command prompt.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
interface{vlan<vlan-id(1-4094>|<interface-type><interface-id>}
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Specify a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
To Next Page
Loading...
Need help?
General
