Siemens SCALANCE S615 - Show Snmp Notif; Show Snmp Targetaddr

Network protocols
6.6 SNMP
SCALANCE S615 Command Line Interface
226 Configuration Manual, 06/2015, C79000-G8976-C406-02
6.6.1.8
show snmp notif
Description
With this command, you display the configured SNMP notification types.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp notif
Result
The configured SNMP notification types are displayed.
6.6.1.9
show snmp targetaddr
Description
This command shows the configured SNMP target addresses.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp targetaddr
Result
The configured SNMP target addresses are displayed.