Siemens SCALANCE S615 - Shutdown

Functions specific to SCALANCE
3.5 SINEMA RC
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
119
3.5.4.9
shutdown
Note
This command is only available with a KEY
-PLUG.
Description
With this command, you disable the connection to the configured SINEMA RC Server.
Requirement
You are in the SINEMARC configuration mode.
The command prompt is as follows:
cli(config-sinemarc)#
Syntax
Call the command without parameter assignment:
shutdown
Result
The connection to the SRC server is terminated.
Further notes
You enable the connection with the no shutdown command.
You display this setting and other information with the
show sinemarc command.