Siemens SCALANCE S615 - Prerule All Ipv4

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
333
cli(config-fw)#
Syntax
Call the command without parameter assignment:
prerule ipv4 show-int
Result
The interfaces are listed.
9.2.4.22
prerule all ipv4
Description
With this command, you enable all predefined firewall rules on the selected interface.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
prerule all ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}
The parameters have the following meaning:
Parameter
Description
Range of values / note
int
Keyword for the interface
-
interface-type
Type or speed of the interface
Specify a valid interface.
num
Interface index Specify a valid interface
index.
0 ... 10
all-int
Enables all predefined firewall rules on all inter-
faces.
-
enabled
Enables the predefined firewall rules.
-
disabled
Disables the predefined firewall rules.
-
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode (Page 313)".