Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
329
Requirement
● The IPv4 firewall rule has been created.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
ipv4rule idx <number(1-100)> set service <string(32)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
idx
Keyword for index
-
number
Number corresponding to a spe-
cific IPv4 rule.
Enter the required number.
1 ... 100
integer
Number of the interface
0 ... 4094
service
Keyword for service or protocol
name
-
Result
The service or protocol name of the corresponding IPv4 firewall rule has been changed.
Further notes
You display this setting and other information with the show firewall ip-rules ipv4
command.
You obtain the numbers with the
ipv4rule show-rules command.
9.2.4.17
ipv4rule set srcip
Description
With this command, you change the source.
Requirement
● The IPv4 firewall rule has been created.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#

Siemens SCALANCE S615 Specifications

General

Protocols	IPsec, OpenVPN
Power Supply	24 V DC
Mounting Type	DIN Rail
Product Name	SCALANCE S615
Ports	5
Firewall	Yes
Weight	0.6 kg
Certifications	CE