Configuration
2.1 System
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
65
The automatic negotiation of connection parameters on an interface is deactivated.
You enable the autonegotiation of connection parameters with the negotiation command.
With this command, you configure the size of the Maximum Transmission Unit (MTU) for an
interface.
● The Interface must be shut down.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
mtu <frame-size(64-1500)>
The parameter has the following meaning:
At system start or when using the restart command with the option memoryor factory, the
following defaults apply:
● The size of the MTU is configured to 1536 bytes.
The setting for the size of the MTU is configured.
You can shut down the interface with the shutdown complete command.
You display this setting with the
show interface mtu command.
You display this setting and other information with the
show interfaces command.
To Next Page
Loading...
Need help?
General
