Siemens SCALANCE S615 - No Snmpagent; Snmp Agent Version

Network protocols
6.6 SNMP
SCALANCE S615 Command Line Interface
230 Configuration Manual, 06/2015, C79000-G8976-C406-02
6.6.2.2
no snmpagent
Description
With this command, you disable the SNMP agent function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no snmpagent
Result
The SNMP agent function is disabled.
Further notes
You enable the SNMP agent function with the snmpagent command.
6.6.2.3
snmp agent version
Description
With this command, you configure whether all SNMP queries or only SNMPv3 queries are
processed.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp agent version{v3only|all}