Siemens SCALANCE S615 - Tia Interface

Network structures
5.1 VLAN
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
169
Result
The ports are reset.
Further notes
You display details of the function with the show vlan command.
You reset the setting with the
no ports command.
5.1.4.7
tia interface
Description
With this command, you enable or disable the TIA interface property. The interface can only
be used for PNIO.
Requirement
● The interface is activated
● You are in the VLAN configuration mode of the VLAN interface with the ID $$$.
The command prompt is
cli (config-if-vlan-$$$) #
Syntax
Call the command without parameters:
tia-interface
Result
The TIA interface is enabled exclusively for the specified VLAN. The function was disabled
on the other interfaces.
Further notes
Note that only one VLAN interface can become the TIA interface.