Functions specific to SCALANCE
3.5 SINEMA RC
SCALANCE S615 Command Line Interface
114 Configuration Manual, 06/2015, C79000-G8976-C406-02
Note
This command is only available with a KEY
-PLUG.
With this command, you configure the device ID. The device ID is assigned when configuring
the device on the SINEMA RC Server. You will find further information on this in the
Operating Instructions of the SINEMA RC Server.
You are in the SINEMARC configuration mode.
The command prompt is as follows:
cli(config-sinemarc)#
Call the command without parameter assignment:
device id <number(0-20000)>
Call up the command with the following parameters:
device id <number(0-20000)>
The parameter has the following meaning:
Device ID Enter the device ID.
The device ID is configured.
You display this setting and other information with the show sinemarc command.
To Next Page
Loading...
Need help?
General
