SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
277
This part contains the sections describing the functions for controlling and balancing network
load.
The flow control function monitors the incoming data traffic of a port. If there is overload
("Congestion", "Overflow") it sends a signal to the connection partner. If the flow control
function receives a signal at the sending end, it stops the data transmission to avoid loss of
data.
This section describes commands of the flow control function.
show flow-control
Description
This command shows the settings of the flow control function.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show flow-control [interface <interface-type><interface-id>]
The parameters have the following meaning:
Keyword for a an interface description
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
To Next Page
Loading...
Need help?
General
