Siemens SCALANCE S615 - 8 Layer 3 Functions; Nat; The Show Commands; Show Firewallnat Masquerading

SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
285
Layer 3 functions
8
8.1
NAT
This section describes commands relevant for NAT / NAPT.
8.1.1
The "show" commands
8.1.1.1
show firewallnat masquerading
Description
This command shows the interfaces on which IP masquerading is enabled.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameter assignment:
show firewallnat masquerading
Result
The interfaces are displayed.