Network structures
5.1 VLAN
SCALANCE S615 Command Line Interface
164 Configuration Manual, 06/2015, C79000-G8976-C406-02
no ip address
Description
With this command, you delete the assignment of an IP address and disable DHCP.
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Call up the command with the following parameters:
no ip address [{ <ucast_addr> | dhcp }]
The parameter has the following meaning:
Value for an IPv4 unicast address Enter a valid IPv4 unicast ad-
Specify this parameter if you want to
disable the DHCP function explicitly.
-
For information on names of addresses and interfaces, refer to the section "Auto-Hotspot".
If DHCP was enabled on this interface, DHCP is now disabled. Any existing dynamically
learned IP address will be automatically converted to a static IP address.
If static IP addresses were configured and if no explicit IP address was transferred as a
parameter, all static IP addresses will be deleted from this interface.
If a static IP address was specified explicitly, this address is deleted from this interface.
Note
Effectiveness of the command
The command is effective immediately.
the interface via which you access the device, you can lose the connection!
You assign an IP address with the ip address or ip address dhcp command.
To Next Page
Loading...
Need help?
General
