Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
334 Configuration Manual, 06/2015, C79000-G8976-C406-02
Result
All predefined firewall rules are enabled on the corresponding interface.
Further notes
You display this setting and other information with the show firewall pre-rules ipv4
command.
You list the available interfaces with the
prerule ipv4 show-int command.
9.2.4.23
prerule dhcp ipv4
Description
With this command, you enable the predefined firewall rule DHCP on the selected interface.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
prerule dhcp ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}
The parameters have the following meaning:
Parameter
Description
Range of values / note
int
Keyword for the interface
-
interface-type
Type or speed of the interface
Specify a valid interface.
num
Interface index Specify a valid interface
index.
0 ... 10
all-int
Enables the predefined firewall rule on all inter-
faces.
-
enabled
Enables the predefined firewall rule.
-
disabled
Disables the predefined firewall rule.
-
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode".

Siemens SCALANCE S615 Specifications

General

Protocols	IPsec, OpenVPN
Power Supply	24 V DC
Mounting Type	DIN Rail
Product Name	SCALANCE S615
Ports	5
Firewall	Yes
Weight	0.6 kg
Certifications	CE