Siemens SCALANCE S615 - No Aggressive

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
386 Configuration Manual, 06/2015, C79000-G8976-C406-02
Syntax
Call the command without parameter assignment:
aggressive
Result
The setting is configured.
Further notes
You display this setting and other information with the show ipsec conn-phase1 command.
You disable the aggressive mode with the
no aggressive command.
9.3.7.2
no aggressive
Description
With this command, you disable the aggressive mode.
Requirement
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs1)#
Syntax
Call the command without parameter assignment:
no aggressive
Result
The setting is disabled. The main mode is used.
Further notes
You display this setting and other information with the show ipsec conn-phase1 command.
You enable the aggressive mode with the
aggressive command.