System time
4.2 NTP client
SCALANCE S615 Command Line Interface
126 Configuration Manual, 06/2015, C79000-G8976-C406-02
This section describes commands relevant for configuration of the NTP client.
show ntp info
Description
This command shows the current settings for the Network Time Protocol (NTP).
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ntp info
The current NTP settings are displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
To Next Page
Loading...
Need help?
General
