Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
404 Configuration Manual, 06/2015, C79000-G8976-C406-02
With this command, you configure the data limit to specify the lifetime of the agreed keys.
When the data limit is reached, the key is renegotiated.
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs2)#
Call up the command with the following parameters:
lifebyte <integer(0-4294967295)>
The parameter has the following meaning:
Enter the data limit in bytes.
The data limit is configured.
You display this setting and other information with the show ipsec conn-phase2 command.
To Next Page
Loading...
