Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
360 Configuration Manual, 06/2015, C79000-G8976-C406-02
You are now in the IPSEC CONNECTION configuration mode.
The command prompt is as follows:
cli(config-conn-X)#
You exit the IPSEC CONNECTION configuration mode with the end or exit command.
You delete a VPN connection with the
no connection name command.
You delete all VPN connections with the
no connection all command.
no connection name
Description
With this command, you delete a specific VPN connection.
● The corresponding VPN connection has been created and is not being used anywhere.
● You are in the IPSEC CONNECTION configuration mode.
The command prompt is as follows:
cli(config-ipsec-conn-X)#
Call up the command with the following parameters:
no connection name <name(122)>
The parameter has the following meaning:
Name of the VPN connection Enter the name of the VPN con-
The corresponding VPN connection is deleted.
You display the VPN connection with the connection name command.
To Next Page
Loading...
Need help?
General
