Configuration
2.1 System
SCALANCE S615 Command Line Interface
42 Configuration Manual, 06/2015, C79000-G8976-C406-02
show interfaces ... counters
Description
This command shows the counters of one, several or all interfaces.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show interfaces
[{<interface-type><interface-id>]|{vlan<vlan-id(1-4094)>}]counters
The parameters have the following meaning:
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available counters.
The counters of the selected interfaces are displayed.
show lldp neighbors
Description
This command shows the current content of the neighborhood table.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
To Next Page
Loading...
Need help?
General
