Siemens SCALANCE S615 - Proxy

Functions specific to SCALANCE
3.5 SINEMA RC
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
117
3.5.4.7
proxy
Note
This command is only available with a KEY
-PLUG.
Description
With this command, you specify that the connection to the defined SINEMA RC Server is
established via a proxy server.
Requirement
● The proxy server is configured.
● You are in the SINEMARC configuration mode.
The command prompt is as follows:
cli(config-sinemarc)#
Syntax
Call up the command with the following parameters:
proxy <string(128)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
string
Proxy server name Specify the proxy server name.
Maximum of 128 characters
Result
The proxy server via which the connection is established is configured.
Further notes
You remove the proxy server with the no proxy command.
You display the available proxy server names with the
srv show-names command.
You display this setting and other information with the
show sinemarc command.