Siemens SCALANCE S615 - DHCP Client; Show Ip Dhcp Client; Renew Dhcp

Network protocols
6.3 DHCP client
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
187
6.3
DHCP client
This section describes commands of the Dynamic Host Configuration Protocol (DHCP).
6.3.1
show ip dhcp client
Description
With this command, you display the configuration settings of the DHCP client.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip dhcp client
Result
The configuration settings of the DHCP client are displayed.
6.3.2
renew dhcp
Description
This command reassigns an IP address to the selected interface via DHCP.
Requirement
● The IP address of the selected interface was assigned via DHCP.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#