Siemens SCALANCE S615 - No Logging Console

Diagnostics
10.1 Event and fault handling
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
421
The parameter has the following meaning:
Parameters
Description
Value
fault-state-id
ID of the mes-
sage
Enter the ID of the message for the "Cold/Warm Start"
event.
To obtain the ID, use the "show events faults status"
command.
Result
The message is acknowledged.
10.1.7
no logging console
Description
With this command, you disable the logging of inputs and outputs to the console.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
no logging console
Result
The logging function is disabled on the console.
Further notes
You enable the setting with the logging console command.
As default the function is "disabled".