Siemens SCALANCE S615 - Commands in the PROXYSERVER Configuration Mode; Srv Name

Network protocols
6.9 Proxy server
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
257
Requirement
You are now in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
proxyserver
Result
You are now in the PROXYSERVER configuration mode.
The command prompt is as follows:
cli(config-proxysrv)#
Further notes
You exit the PROXYSERVER configuration mode with the end or exit command.
6.9.3
Commands in the PROXYSERVER configuration mode
This section describes commands that you can call up in the PROXYSERVER configuration
mode.
In the Global configuration mode, enter the proxyserver command to change to this mode.
● If you exit the PROXYSERVER configuration mode with the
exit command, you return to
the Global configuration mode.
● If you exit the PROXYSERVER configuration mode with the
end command, you return to
the Privileged EXEC mode.
6.9.3.1
srv name
Description
With this command, you create a proxy server entry. You assign a name and configure the
parameters.
Requirement
You are in the PROXYSERVER configuration mode.
The command prompt is as follows: