Siemens SCALANCE S615 - Srv Name Pw

Network protocols
6.9 Proxy server
SCALANCE S615 Command Line Interface
262 Configuration Manual, 06/2015, C79000-G8976-C406-02
Requirement
● The proxy server name has been created.
● You are in the PROXYSERVER configuration mode.
The command prompt is as follows:
cli(config-proxysrv)#
Syntax
Call up the command with the following parameters:
srv name <string(128)> port <number(0-65535)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
string
Proxy server name Specify the proxy server
name.
Maximum of 128 characters
Port Port number Specify the port number on
which the proxy service runs.
0 - 65535
Result
The port has been changed.
Further notes
You display the available proxy server names with the srv show-names command.
You create the proxy server with the
srv name command.
6.9.3.6
srv name pw
Description
With this command, you change the password for access to the proxy server.
Requirement
● When selecting the authentication method basic is used.
● The proxy server name has been created.
● You are in the PROXYSERVER configuration mode.
The command prompt is as follows:
cli(config-proxysrv)#