Network protocols
6.4 DHCP server
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
191
This section describes commands relevant for configuring the DHCP server.
The connected devices are configured so that they obtain the IPv4 address from a DHCP
server.
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
show ip dhcp-server bindings
Description
This command shows the current assignments of IPv4 addresses of the DHCP server.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameter assignment:
show ip dhcp-server bindings
The information is displayed.
To Next Page
Loading...
Need help?
General
