Siemens SCALANCE S615 - Ipv4 Rule Set Prior; Ipv4 Rule Set Service

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
328 Configuration Manual, 06/2015, C79000-G8976-C406-02
9.2.4.15
ipv4rule set prior
Description
With this command, you change the priority of the IPv4 firewall rule.
Requirement
● The IPv4 firewall rule has been created.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
ipv4rule idx <number(1-100)> set prior <number(0-64)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
idx
Keyword for index
-
number
Number corresponding to a spe-
cific IPv4 rule.
Enter the required number.
1 ... 100
prior
Keyword for the priority
-
integer
Priority Enter the priority for the IPv4 rule.
0 ... 64
Result
The priority of the corresponding IPv4 firewall rule has been changed.
Further notes
You display this setting and other information with the show firewall ip-rules ipv4
command.
You obtain the numbers with the
ipv4rule show-rules command.
9.2.4.16
ipv4rule set service
Description
With this command, you change the service or protocol name.