Siemens SCALANCE S615 - Service Show-Names; Shutdown

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
353
Further notes
You display the available service names with the service show-names command.
You create the service with the
service cr name command.
You display this setting and other information with the
show firewall ip-services
command.
9.2.4.42
service show-names
Description
With this command, you display the available service names.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call the command without parameter assignment:
service show-names
Result
The service names are listed.
Further notes
You create a protocol with the service cr name command.
9.2.4.43
shutdown
Description
With this command, you disable the firewall.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#