Security and authentication
9.4 Certificates
SCALANCE S615 Command Line Interface
410 Configuration Manual, 06/2015, C79000-G8976-C406-02
With this command, you delete a specific certificate or all certificates.
● Certificates are loaded and are not being used anywhere.
● You are in the CERT configuration mode.
The command prompt is as follows:
cli(config-cert)#
Call up the command with the following parameters:
del { <idx(1-100)> | all }
The parameters have the following meaning:
Number corresponding to a specific certificate. Enter the required number.
Deletes all certificates. ---
The relevant certificate is deleted.
You load certificates with the tftp load command.
You show the available certificates with the
show-idx command.
You display the use of the certificate with the
show-info command.
To Next Page
Loading...
