Network protocols
6.6 SNMP
SCALANCE S615 Command Line Interface
240 Configuration Manual, 06/2015, C79000-G8976-C406-02
Type of the SNMP notification
•
Trap
generates a trap
• Inform
generates a log entry or sends
an entry to the log server
Storage type specifies whether the settings remain
following a restart:
•
volatile (volatile):
The settings are lost after a
restart
•
nonvolatile (non-volatile):
The settings are retained after
a restart
The details of the SNMP notifications are configured.
You delete the details of an SNMP group with the no snmp notify command.
You display the configured SNMP notifications with the
show snmp notif command.
You display the configured SNMP target addresses with the
show snmp targetaddr
command.
no snmp notify
Description
With this command, you delete the details of the SNMP notifications.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
no snmp notify <NotifyName>
To Next Page
Loading...
Need help?
General
