Siemens SCALANCE S615 Configuration Manual

Network protocols
6.1 IPv4 protocol
SCALANCE S615 Command Line Interface
180 Configuration Manual, 06/2015, C79000-G8976-C406-02
The parameter has the following meaning:
Parameter
Description
Range of values / note
prefix
Specifies the IP address or the address
range
specify a valid IP address
mask
Specifies the subnet mask used for
prefix.
Use decimal notation.
enter a valid subnet mask
next-hop
specifies the IP address to which the
selected addresses were forwarded.
specify a valid IP address
distance
The value for the administrative dis-
tance.
1 ... 255
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The entry is deleted.
Further notes
You configure an entry from the IP routing table with the ip route command.
You display the IP routing table with the
show ip route command.
6.1.2.7
ip routing
Description
With this command, you enable the routing function for IPv4.
Note
This command is available only with layer 3. DHCP must not be enabled on any IP interface.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ip routing

Siemens SCALANCE S615 Specifications

General

Protocols	IPsec, OpenVPN
Power Supply	24 V DC
Mounting Type	DIN Rail
Product Name	SCALANCE S615
Ports	5
Firewall	Yes
Weight	0.6 kg
Certifications	CE