Network protocols
6.11 SSH server
SCALANCE S615 Command Line Interface
274 Configuration Manual, 06/2015, C79000-G8976-C406-02
This section describes commands of the Secure Shell (SSH) Server.
This command shows the settings of the SSH server.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ip ssh
The settings for the SSH server are displayed.
Commands in the Global Configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
To Next Page
Loading...
Need help?
General
