Siemens SCALANCE S615 - No Src-Nat All

Layer 3 functions
8.1 NAT
SCALANCE S615 Command Line Interface
300 Configuration Manual, 06/2015, C79000-G8976-C406-02
Syntax
Call up the command with the following parameters:
no src-nat srcint <if-type> [<num(0-4094)>] dstint <if-type(50)> [<num(0-4094)>] idx
<num(1-200)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
srcint
Keyword for the source interface
-
if-type
Type or speed of the interface Specify a valid interface.
num
Number of the addressed interface
0 ... 4094
dstint
Keyword for the destination interface -
if-type
Type or speed of the interface
Specify a valid interface.
num
Number of the addressed interface
0 ... 4094
idx
Keyword for the number of the source NAT rule
-
num
Number corresponding to a specific source NAT
rule.
Specify a valid number.
0 ... 200
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL NAT configuration mode (Page 288)".
Result
The specified source NAT rule is deleted.
Further notes
You delete all source NAT rules with the no src-nat all command.
You create a source NAT rule with the
src-nat type ipv4. command.
You display the numbers of the source NAT rules with the
src-nat show-idx command.
8.1.3.13
no src-nat all
Description
With this command, you delete all source NAT rules.
Requirement
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#