Siemens SCALANCE S615 - Icmp Name

Security and authentication
9.2 Firewall
SCALANCE S615 Command Line Interface
314 Configuration Manual, 06/2015, C79000-G8976-C406-02
In the Global configuration mode, enter the firewall command to change to this mode.
● If you exit the FIREWALL configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the FIREWALL configuration mode with the
end command, you return to the
Privileged EXEC mode.
Available interfaces
As the source and destination interfaces, the following interfaces are available:
Interface
prede-
fined
firewall
rules
own firewall
rules
VLAN
VLANs with configured subnet
x
x
vlan (1-x)
PPP
(M874,
M876-3)
WAN interface EGPRS, GPRS,
UMTS
x x
ppp 0
USB
(M876-4)
WAN interface LTE x x
usb 0
IPsecVPN
All IPsecVPN connections
-
x
ipsecALL
Specific IPsecVPN connection
-
x
ipsec num
SINEMA RC
Connection to SINEMA RC Server
-
x
sinemarcall
Device
Connection to the device
-
x
device
x: available
- : not available
9.2.4.1
icmp name
Description
With this command, you create an ICMP service. You select a service name and assign the
service parameters to it.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
icmp name <string(32)> type <num(0-256)> code <num(0-256)> ver ipv4