Layer 3 functions
8.1 NAT
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
301
Call the command without parameter assignment:
src-nat del all
The source NAT rules are created.
You create a source NAT rule with the src-nat type ipv4. command.
src-nat show-idx
Description
With this command, you show the numbers of the configured source NAT rules.
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Call the command without parameter assignment:
src-nat show-idx
The numbers are listed.
You delete a source NAT rule with the no src-nat. command
You delete all source NAT rules with the
no src-nat all command.
You create a source NAT rule with the
src-nat type ipv4 command.
To Next Page
Loading...
Need help?
General
