Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
368 Configuration Manual, 06/2015, C79000-G8976-C406-02
With this command, you specify the type of the remote station address.
You are in the IPSEC REMOTE END configuration mode.
The command prompt is as follows:
cli(config-ipsec-rmend-X)#
Call up the command with the following parameters:
addr-mode <manual|any>
The parameters have the following meaning:
Accepts the connection from remote
stations with a specific address.
• In Roadwarrior mode
Only accepts connections
from remote stations with a
fixed IP address (/32),
fixed IP subnet (CIDR nota-
tion), or (D)DNS host name.
• In standard mode
Only establishes a connection
to a specific remote station
with a fixed IP address
or with (D)DNS host name.
Or only accepts a connection
from a specific remote station
with a fixed IP address or with
Accepts the connection from remote
stations with any IPv4 address.
Only in Roadwarrior mode
The setting is specified.
You configure the mode with the conn-mode command.
You configure the IP address with the
addr command.
To Next Page
Loading...
