Siemens SCALANCE S615 - No Pool-Enable

Network protocols
6.4 DHCP server
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
203
Result
The setting is enabled.
Note
If the IPv4 address ba
nd is enabled, DHCP options (option ...) and static assignments (static
leases) can no loner be edited.
Further notes
You display the setting with the show ip dhcp-server pools command.
You disable the setting with the
no pool-enable command.
6.4.3.7
no pool-enable
Description
With this command you specify that this IPv4 address band will not be used.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call the command without parameter assignment:
no pool-enable
Result
The setting is disabled.
Further notes
You display the setting with the show ip dhcp-server pools command.
You enable the setting with the
pool-enable command.