Siemens SCALANCE S615 - Show Events Smtp-Port; Commands in the Events Configuration Mode

Network protocols
6.10 SMTP client
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
267
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show events sender email
Result
The configured e-mail sender address is displayed.
6.10.1.3
show events smtp-port
Description
This command shows the configured SNMP port.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show events smtp-port
Result
The configured SMTP port is displayed.
6.10.2
Commands in the Events configuration mode
This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the
events command to change to this mode.