Siemens SCALANCE S615 - Auth Psk

Security and authentication
9.3 IPsec VPN
SCALANCE S615 Command Line Interface
380 Configuration Manual, 06/2015, C79000-G8976-C406-02
You display this setting and other information with the show ipsec conn-authentication
command.
You show the available certificates with the
show-idx command.
You show the configuration of the IPsec connection with the
show ipsec connections
command.
You remove the authentication with the
no auth command.
9.3.6.2
auth psk
Description
With this command you specify that a key will be used for authentication.
Requirement
You are in the IPSEC AUTHENTICATION configuration mode.
The command prompt is as follows:
cli(config-conn-auth)#
Syntax
Call up the command with the following parameters:
auth psk <string(255)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
string
Value for the key
Specify a valid key.
Result
The key is configured.
Further notes
You display this setting and other information with the show ipsec conn-authentication
command.
You remove the authentication with the
no auth command.