Siemens SCALANCE S615 - No Netmap

Layer 3 functions
8.1 NAT
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
295
netmap destination srcint <if-type> [<num(0-4094)>] dstint <if-type> [<num(0-4094)>]
type ipv4
srcip <subnet> dstip <subnet> transip <subnet>
The parameters have the following meaning:
Parameter
Description
Range of values / note
srcint
Keyword for the source interface
-
if-type
Type or speed of the interface Specify a valid interface.
num
Number of the addressed interface
0 ... 4094
dstint
Keyword for the destination interface
-
if-type
Type or speed of the interface
Specify a valid interface.
num
Number of the addressed interface
0 ... 4094
srcip
Keyword for the source subnet.
subnet
The subnet can also be a single PC or another
subset of the subnet.
Specify the subnet in the
CIDR notation.
dstip
Keyword for the destination subnet
-
subnet
The subnet can also be a single PC or another
subset of the subnet.
Specify the subnet in the
CIDR notation.
transip
Keyword for the subnet with which the destina-
tion subnet is replaced.
-
subnet
The subnet can also be a single PC or another
subset of the subnet.
Specify the subnet in the
CIDR notation.
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL NAT configuration mode (Page 288)".
Result
The NETMAP rule for the address translation of the destination IP address has been
created. During creation, an entry with a unique number (index) is created.
Further notes
You delete a NETMAP rule with the no netmap command.
You delete all NETMAP rules with the
no netmap all command.
You display the numbers of the NETMAP rules with the
netmap show-idx command.
You display the NETMAP rule with the
show firewallnat netmap-nat command.
8.1.3.8
no netmap
Description
With this command, you delete a specific NETMAP rule.