Configuration
2.2 Load and Save
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
77
With this command, you configure the access to a TFTP server.
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Call up the command with the following parameters:
tftp server ipv4 <ipv4-address>[port<tcp port(1-65535)>]
The parameters have the following meaning:
Keyword for an IPv4 address
Value for an IPv4 unicast address Enter a valid IPv4 unicast ad-
dress.
Keyword for the port of the server via
which the TFTP connection runs
-
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The settings for the access to the selected TFTP server are configured.
To Next Page
Loading...
Need help?
General
