Siemens SCALANCE S615 - Commands in the DDNS Client Configuration Mode; Service

Network protocols
6.5 DNS
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
217
Syntax
Call the command without parameter assignment:
no shutdown
Result
The setting is enabled.
Further notes
You disable the setting with the shutdown command.
6.5.5
Commands in the DDNS Client configuration mode
This section describes commands that you can call up in the DDNS CLIENT configuration
mode.
In the Global configuration mode, enter the
ddnsclient command to change to this mode.
● If you exit the DDNS CLIENT configuration mode with the
exit command, you return to
the Global configuration mode.
● If you exit the DDNS CLIENT configuration mode with the
end command, you return to the
Privileged EXEC mode.
6.5.5.1
service
Description
With this command, you enable the dynamic DNS provider.
Requirement
You are in the DDNS Client configuration mode.
The command prompt is as follows:
cli(config-ddnsclient)#
Syntax
Call up the command with the following parameters:
service {show-services | <index>}