Layer 3 functions
8.1 NAT
SCALANCE S615 Command Line Interface
288 Configuration Manual, 06/2015, C79000-G8976-C406-02
Call the command without parameters:
firewallnat
You are now in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
You exit the FIREWALL NAT configuration mode with the end or exit command.
Commands in the FIREWALL NAT configuration mode
This section describes commands that you can call up in the FIREWALL NAT configuration
mode.
In the Global configuration mode, enter the
firewallnat command to change to this mode.
● If you exit the FIREWALL NAT configuration mode with the
exit command, you return to
the Global configuration mode.
● If you exit the FIREWALL NAT configuration mode with the
end command, you return to
the Privileged EXEC mode.
As the source and destination interfaces, the following interfaces are available:
VLANs with configured subnet
PPP
(M874,
M876-3)
WAN interface EGPRS, GPRS,
UMTS
x x
USB
WAN interface LTE x x
IPsecVPN
Specific IPsecVPN connection
Connection to SINEMA RC Server
To Next Page
Loading...
Need help?
General
