Network protocols
6.4 DHCP server
SCALANCE S615 Command Line Interface
202 Configuration Manual, 06/2015, C79000-G8976-C406-02
The parameters have the following meaning:
Code of the DHCP option Enter a valid DHCP option.
The following DHCP options are not sup-
ported:
• 50 - 60
• 255
DHCP parameter in hexadecimal Enter a valid hexadecimal value.
Format: XXXXX e.g. C0A86402
The DHCP option is configured. In total a maximum of 20 DHCP options are possible.
You display the setting with the show ip dhcp-server-pools command.
You disable the IPv4 address band with the
no pool-enable command.
You delete the DHCP option with the
no option command.
With this command you specify that this IPv4 address band will be used.
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Call the command without parameter assignment:
pool-enable
To Next Page
Loading...
Need help?
General
